(I will set the opacity to about 65%.)įinally, I will brighten the wall with a Color Dodge layer, and it’s done. I will draw the pattern of the curtain on a Normal layer. Now, I just need to adjust the light of each detailed part.įirst, I will brighten the face a little using Overlay. If I set the blending mode of the layer back to Normal, you can see the parts where I put the lights. (I set the opacity of the layer to about 60%.) Now, I am going to add the light from the window.Ĭreate a new layer and set its blending mode to Color Dodge, then color the parts where the light hits.Īs you can see in the picture, if I set the blending mode back to Normal, these are the parts where I added the lights.Ĭreate a Color Dodge layer and paint the glass reflection with a light blue color. The face is hard to see when it’s shaded, so I removed the shadows around the eyes with an airbrush.Ĭreate a new layer inside the character group and set its blending mode to Color Dodge.Īdd the light on the edges of the character with a bluish color, and place this layer above the background shadows layer.ĭarken the background shadows. Set the blending mode back to Normal and take a look at the painted parts. (Set the opacity to about 77%.)Įrase the parts where the light hits with the transparent color. Indoor ShadowsĬreate a new layer above the character group and set its blending mode to Multiply.įill the layer with a bluish color. I will start by adding the indoor shadows and the light from the window. Next, I am going to adjust the shadows of the whole illustration, including the character. I wanted the background to be a little darker, so I created a new layer and set its blending mode to Screen, then I filled it with dark brown. That’s why I am using a Multiply layer for the background this time. Overlay increases the saturation, so the illustration will turn out too bright if I use it for both the character and the background. When I colored the character, I used Overlay, but for the background, I used Multiply to color each part. If I set the blending mode back to Normal, you can see how I colored each part. Then, create another layer and set its blending mode to Multiply. Make a group to put the background layers in it.Ĭreate a new layer above the background layer and set its blending mode to Overlay.Ĭolor the entire background with a light brown color.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |